Page 1 of 1

Pipe Thermal Expansion

Posted: Thu Jul 23, 2020 5:41 am
by flishaa
Dears,

I have used ASME 31.3 Code which the thermal expansion start at 20C as zero expansion, but when I calculate py Start Prof I found that the Zero point at 0C.
Is there any setting to modify it?

Thank you

Mohamed

Re: Pipe Thermal Expansion

Posted: Thu Jul 23, 2020 4:41 pm
by Alex Matveev
Hello, Mohamed

Yes, sure. You can modify it in project settings:
2020-07-23_19-38-50.png
2020-07-23_19-38-50.png (154.75 KiB) Viewed 5305 times
And also you can set individual ambient temperature for each operation mode:
2020-07-23_19-39-14.png
2020-07-23_19-39-14.png (161.91 KiB) Viewed 5305 times