Please write to support@passuite.com

Please send it to support@passuite.com we will check what happened

it is ring bending stress. Calculated using nonlinear FEA https://www.passuite.com/kbase/doc/star ... Stress.htm

Hello, The gaps less than 5 mm are not recommended to be taken into account during stress analysis. It is just a technological gap that may actually be absent. The accuracy of such a gap cannot be ensured during installation. START-PROF ignore gaps less than 5 mm in standard guide supports . But if ...

The answer is posted here https://blog.passuite.com/bourdon-effec ... ial-force/

A question. The correct answer will be posted later in comments. More information about pipe stress analysis here: https://passuite.com/start#resources-tab You have a pipe restrained between two anchors. Thermal expansion is zero. Internal pressure is high. The axial force will be (explain why): 1) ...

General information can be found here: https://passuite.com/download/resource/start/PASS%20START-PROF%20Capabilities%20for%20Oil%20&%20Gas%20Gathering,%20Upstream%20and%20Midstream%20Pipelines.pdf https://www.passuite.com/kbase/doc/start/WebHelp_en/index.htm#t=gruntmodel.htm&rhsearch=subside...

Additional information about HDPE plastic piping analysis including PE 4710: https://www.passuite.com/kbase/doc/start/WebHelp_en/index.htm#t=Plastic.htm https://www.passuite.com/kbase/doc/start/WebHelp_en/index.htm#t=news.htm https://youtu.be/y1099VY7zq4 https://youtu.be/0_ffI9offd8 https://whatispi...

Hello, Mohamed

Yes, sure. You can modify it in project settings:
And also you can set individual ambient temperature for each operation mode:

Select Thermoplastic piping